Blue Diamond POWER RAKE - Page 29

29
Power Rake Operation and Maintenance Manual
Maintenance
Lubrication (Cont’d)
Figure 5
Apply 2-3 pumps of grease to the grease zerk
(Item 1) [Figure 5] on the gauge wheel spindles.
Figure 6
Apply a coat of grease to the inside upper pivot
plate (Item 1) and lower pivot plate (Item 2)
[Figure 6].
Chain Case Oil
NOTE: The chain case oil should be changed
after the first 100 hours or 30 days of
operation and 250 hours thereafter.
Figure 7
NOTE: To check the chain case oil, park the
power rake on a smooth level surface.
Remove the bolt (Item 1) [Figure 7]. If no
oil present, fill the chain case with 80/
90W oil until oil leaks out the bolt hole.
Install bolt.
Chain Case Oil Change
Place a pan below the chain case, remove the
bolts on the lower cover (Item 1) [Figure 7] and
remove lower cover. Drain the oil.
Remove all oil from gearbox, install new gasket
and lower cover with bolts (Item 1) [Figure 7]
previously removed.
Fill chain case with 80/90W oil to bolt (Item 1)
[Figure 7] level. Reinstall bolt.
1
1
1
2
1