2-6. CHARGING BATTERIES
Charging requirements will vary depending on depth of
discharge and temperature. Follow safety rules when
placing a battery on charge.
Proceed as follows:
1. Park vehicle at charging station with platform
lowered and turn the key switch OFF.
2. Apply the emergency disconnect switch.
3. Check the condition
of the cord. If there are any
cuts in the cord, any exposed wires, loose plugs
or connectors, DO NOT attempt to charge the
batteries.
4. Connect plug from the vehicle to a power outlet
and charge the battery according to Supplement
374 *.
Figure 2-1 Battery Charging
2-7. REPLACING BATTERIES
4. Disconnect the battery cables from the batteries.
5. Carefully lift the batteries out of the vehicle.
6. for installation please reverse step 1-5.
Replace only with original OEM batteries or batteries
approved by an authorized Blue Giant dealer.
Contact your authorized Blue Giant dealer for
information on optional batteries and battery chargers.
WARNING: The weight and dimensions of the
battery have considerable affect on
the operational safety of the vehicle.
Battery equipment may only be replaced
with the agreement of the manufacturer.
2-7.1. Battery disposal:
Dispose in accordance with national environmental
protection regulations or disposal laws. The
manufacturer’s disposal instructions must be followed
1. Engage the emergency power disconnect switch
and turn off key switch.
2. Remove the compartment cover as described in paragraph
4-2.1.
3. Remove the four screws, lock washers and flat
washers that holds the battery brackets in place.
To Next Page
Loading...