SECTION 5
BRAKE SERVICING
5-1. BRAKES.
The brake system consists of a drive motor mounted
brake. This brake is spring applied and electrically
released. Figure 5-1
5-1.1. Brake Assembly Replacement
1. Engage the emergency power disconnect switch
and turn off key switch.
2. Block load wheels.
3. Remove the compartment cover as described in
paragraph 4-2.1.
4. Disconnect electric brake from harness.
5. Remove the mounting screws and brake.
6. Place the new brake into position and secure with
the mounting screws.
7. Reconnect electric brake to harness.
8. Install the cover as described in paragraph 4-2.2.
9. Remove load wheel blocks and check operation.
10. Disengage the emergency power disconnect
switch and turn on key switch.
To Next Page
Loading...