CAUTION
• Only trained personnel should operate or service this equipment.
• Always park the In-Plant Table equipment after use.
• Conduct routine inspections and maintenance. Failure to do so could cause equipment damage and or personal injury.
• Always contact your Blue Giant Dealer immediately if a malfunction occurs.
NOTICE
• Do not ground welding equipment to any electrical components.
• Do not attach welder as ground to lift platform when welding on base frame assembly. Attach welder ground to base frame
assembly only.
• Do not allow the drill to go too deeply when drilling holes in the control box. Damage to the control systems may occur.
• Never use air to blow debris from control box. Use a vacuum to remove debris from control box.
• Do not connect green ground lead into control box until all welding has been completed.
• Always keep the work area clean and free of litter.
• Always clean all side openings of dirt and debris.
• Always clean up dry and liquid spills immediately after they occur.
• Always maintain proper lighting in the work area.
• If a procedure is not clearly defined in this manual, contact your Blue Giant Dealer.
IN-PLANT LFT LIFT TABLE — OWNER'S MANUAL
9ISSUE DATE: NOVEMBER 15, 2023 REV. 1.0 (PART # 038-475E)
To Next Page
Loading...
