8.0 OPERATING INSTRUCTIONS
Depending on the In-plant installation, the lift table may have controls available. Consult the specific installation wiring diagram for these
options, if present.
8.1 LOAD TRANSFER
When transferring loads onto and off of a lift table, the cargo weight distribution should NEVER exceed the maximum value on the weight
rating decal. The lift table weight rating decal lists the maximum load values for the lift table.
8.2 RAISING OR LOWERING LIFT TAbLE
The following Danger and Warning list apply to any lift table.
DANGER
• While lift table is moving, keep people and objects clear of areas under the platform and in the immediate lift table area.
• Fully read and understand the lift table operation. Practice safe load transfer methods. If you do NOT understand the complete
lift table operating procedure and safe load transfer methods, refer to the Owner/Operator regarding local regulatory/jurisdictional
and facility requirements.
• While monitoring the lift table, be aware of potential fall risks from deck edges.
WARNING
• The lift table operator(s) must be present during all steps of this procedure.
• The lift table operator(s) must keep an unobstructed view of lift table, any operation light/horn/bell, and other operators to ensure
safe operation.
• Do not exceed (rated/lift table) capacity or load classification of lift table as listed on the manufacturer/product nameplate. Capacity
includes: any object(s) on the deck/platform. See “2.4 OWNER’S RESPONSIBILITY” on page 7. For nameplate location, see
“10.0 DECAL IDENTIFICATION AND LOCATION” on page 26.
• To avoid bodily injury, stand clear of lift table while it is moving.
Read and understand these instructions and safety rules before operating lift table:
• Before using lift table, inspect it for proper operation and condition. If any unsafe condition exists, remove unit from service until
repairs are made.
• Before using lift table, inspect any/all safety devices to verify that they are in place and functioning properly.
• Prior to placing a load on lift table, read and understand the rated capacity of the unit, as labeled on the nameplate attached to the
side of the deck assembly. The rated lift table capacity is the maximum uniformly distributed load permitted for the unit.
IN-PLANT LFT LIFT TABLE — OWNER'S MANUAL
19ISSUE DATE: NOVEMBER 15, 2023 REV. 1.0 (PART # 038-475E)
To Next Page
