3.0 SAFETY MESSAGE COLOR IDENTIFICATION
This manual includes color-coded safety messages that clarify instructions and specify areas where potential hazard exists. To reduce
the possibility of equipment damage and serious injury or death, please follow the instructions and understand the warnings contained
in the messages. If warning decals become damaged or missing, replace them immediately. Avoid accidents by recognizing dangerous
procedures or situations before they occur.
DANGER
Serious injury or death will likely occur if the instructions are not followed.
WARNING
Serious injury or death may occur if the instructions are not followed.
CAUTION
Instructions marked caution concern safe operating procedure. Failure to comply may result in personal injury.
NOTICE
Procedures marked notice must be followed in order to reduce damage to machinery.
3.1 OPERATIONAL SAFETY WARNINGS
These are safety warnings that may be part of a procedure or hardware warning decal.
DANGER
• BEFORE BEGINNING ANY SERVICE PROCEDURES:
– Disconnect the power and follow all lockout / tagout procedures, as per OSHA requirements. Refer to wiring diagrams.
• Never operate a broken or damaged In-Plant Table. Repair immediately by a qualified service technician.
• All loads must be centered and secured from rolling off the platform. Loose or unbalanced loads are dangerous.
• While transferring load, be aware of potential fall risks from table edges.
WARNING
• Do not use fingers or hands to remove foreign materials.
• Deck may drop unexpectedly, keep people and objects clear of the area immediately under or near the lift table.
• Post safety warnings and barricade working area around the In-Plant Table and at ground level to reduce unauthorized use of the lift
during maintenance/service.
• Lift operator must be present during all steps of this procedure and keep an unobstructed view of lift to ensure safe operation.
Never leave the In-plant LFT Lift Table unattended in the raised position.
• Never leave loads sitting on the In-plant LFT Lift Table.
• Do not operate the In-plant LFT Lift Table beyond its rated capacity. Before load transfers, verify the load does not exceed the single
axle rolling load maximum rating as found on nameplate of the In-plant LFT Lift Table.
• Never attempt to lift or hold the table by hand unless instructed by this manual and using caution. Serious personal injury could
occur.
IN-PLANT LFT LIFT TABLE — OWNER'S MANUAL
8 ISSUE DATE: NOVEMBER 15, 2023 REV. 1.0 (PART # 038-475E)
To Next Page
Loading...
