bluelab Guardian Monitor User Manual

Bluelab Guardian Monitor
Bluelab Corporation Limited 6 Version1:180809_bl
STEP 1 – Mounting the Monitor
If wall mounting;
Select a suitable location that is less than 2 meters
from your tank, and less than 1.5 meters from an
electrical mains outlet.
NOTE: Avoid placing the monitor where it can be
damaged by direct sunlight, water or nutrient salts.
Option 1
1. Install both top and bottom centre fasteners
to the wall. (172mm / 6.¾” apart)
2. Slide the monitor onto the fasteners.
Option 2
1. Fix the four fasteners through each mounting
hole in each corner of the case.
If mounting on a support or bar;
1. Select a suitable location that is less than 2
meters from your tank, and less than 1.5
meters from an electrical mains outlet.
NOTE: Avoid placing the Monitor where it can be
damaged by nutrient salts.
2. Fix each of the cable ties provided through the
small mounting holes in the top of the case
and wrap around the support/bar and secure.
STEP 2 - Install correct plug adaptor
1. Select the appropriate mains plug adaptor for
your country.
2. Connect the plug adaptor to the power supply.
STEP 3 – Connect power adaptor and
pH Probe
1. Connect power adaptor into base of monitor
where ‘Power Input’ is labelled, and plug
adaptor into mains power supply.
2. Connect the pH Probe to the monitor.
STEP 4 – Power up
1. Switch on power adaptor at the mains.
2. When power is applied the Guardian will
complete a display test sequence.
Option 1;
Mounting keyholes
top and bottom
Cable ties fixed through small mounting holes
around a support or bar
Option 2;
Mounting holes
top and bottom

bluelab Guardian Monitor Specifications

General

Brand	bluelab
Model	Guardian Monitor
Category	Measuring Instruments
Language	English