BLUM AVENTOS HL Installation

8
Blum switch
Function The Blum switch is battery-operated (CR2032).
Only use batteries from well-known manufacturers.
When the battery power begins to weaken, the battery display (LED) begins to
flash red.
NOTICE
⇒ If the battery is inserted incorrectly, the Blum switch battery display
flashes red.
Battery display (LED)
⇒ This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful interfe-
rence, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Replacing the battery
⇒ Open the Blum switch
CAUTION
⇒ The Blum switch battery must not be recharged or thrown into fire.
⇒ Remove the battery
⇒ Insert new battery
Type: CR2032
⇒ Close Blum switch
Please note proper
pole connections (+/-)
Schalter
21P5020
FCC ID: W95-21P5020

BLUM AVENTOS HL Specifications

General

Category	Lift system
Cabinet width range	Up to 1800 mm
BLUMOTION	Yes
SERVO-DRIVE	Optional
Application	Lift system for wall cabinets
Cabinet height range	300 mm to 580 mm
Motion technology	BLUMOTION
Material	Steel
Adjustment	3-dimensional adjustment
Opening Angle Stop	Optional
Mounting	Screw-on system