37 BA-077/1EN M6X.20XX
5.1 - Maintenance
5.1.1) Maintenance
• Regularly remove drilling dust from the machine.
• Remove dirt and water residue that collects in the air filter unit (D8) on a regular basis
• Check the electrical and compressed air lines on a regular basis
5.1.2) Replacing a damaged gearbox coupling
ATTENTION
Replace broken or damaged parts immediately.
Only use Blum original parts.
• Use a flathead screwdriver to remove the damaged coupling
• Slip the replacement coupling onto the shaft until it aligns with the shaft at the top
5 - Maintenance and service
To Next Page
Loading...
