BLUM SERVO-DRIVE

5
EN
transformer).
• The outlet must be freely accessible.
• Only 1 Blum transformer can be connected to each distribution
cable.
• Maintain safety distances to the Blum transformer listed in the in-
stallation instructions.
• Make sure that moisture cannot penetrate the Blum transformer
and drive unit.
• Before starting repair or maintenance work, unplug the Blum
transformer to disconnect the power.
• The drive unit, Blum transformer and SERVO-DRIVE switch should
only be cleaned with a moist cloth because penetrating moisture
and aggressive cleaning materials can damage the electronics.
• Do not touch the area around the lever during the opening and
closing motion.
• No damaged parts should be used.
• Sharp edges may damage the cable.
• Neither the Blum transformer nor any cabling should come into
contact with moving parts.
• Never take apart a drive unit or a SERVO-DRIVE switch.
Intended use
SERVO-DRIVE supports the opening and closing of lift systems and/
or the opening of pull-out elements, and may only be used under the
following conditions:
• In dry, enclosed rooms.
• In combination with AVENTOS lift systems and/or pull-out systems
from Julius Blum GmbH within permitted technical specifications.
• In combination with a Blum transformer.