BLUM SERVO-DRIVE

4
Using the installation instructions
Please read the installation instructions and safety information before
SERVO-DRIVE installation.
We recommend that you use the orientation diagram for easier identi-
fication of the parts being described.
These installation instructions apply to the SERVO-DRIVE electrical
motion support system for:
- the lift systems AVENTOS HF, AVENTOS HS, AVENTOS HL,
AVENTOS HK and AVENTOS HK top
- the box systems LEGRABOX and TANDEMBOX as well as the run-
ner systems MOVENTO and TANDEM
However, only AVENTOS HF is used as an example in the illustra-
tions.
Please see the special AVENTOS installation instructions for the as-
sembly steps for the mechanical AVENTOS HF, HS, HL, HK and HK
top lift systems without SERVO-DRIVE.
Safety
SERVO-DRIVE complies with current safety standards.
Nevertheless, there are certain risk factors if these installation instruc-
tions are not followed. Please be aware that Julius Blum GmbH is not
responsible for incidental or consequential damages that may arise
due to non-compliance with these installation instructions.
• All national standards must be followed for SERVO-DRIVE as-
sembly. This includes, in particular, those related to the mechanical
safety of moving parts and electrical cabling.
• Only qualified technicians may install/replace Blum components,
modify the position of the Blum transformer or modify any cabling.
• The device may only be connected to a power supply that corre-
sponds to the type and frequency listed on the serial tag (see Blum
Warning signs and danger symbols
WARNING indicates a danger that could lead to
death or serious injury if not heeded.
The NOTE sign indicates information that should
be followed.
WARNING
NOTE