LD6 AND MD8 HOSE INSTALLATION
25
(13) Connect end of “right stabilizer up” hose (item
11) equipped with short 90° fitting to lower Port (Point
L1) on fifth valve section from right as shown in Fig. 13.
Route hose behind all other hoses inside mainframe,
through the hole in right side plate and connect to the
rod end (Point L2) of right stabilizer cylinder as shown
in Fig. 14. Fasten the hose approximately 2” below the
base end Port of the stabilizer cylinder.
Fig. 13
Fig. 14
(14) Connect end of “right stabilizer down” hose (Item
10) equipped with long 90° fitting to upper Port (Point
M1) as shown in Fig. 13. Route hose in same manner as
stabilizer up hose and connect to base end Port
(Point M2) on right stabilizer cylinder as shown in Fig.
14.
(15) Connect end of “left stabilizer up” hose (Item 13)
equipped with short 90° fitting to lower Port (Point N1)
on far left hand valve section as shown in Fig. 15. Route
hose through hole in left side plate and connect to the
rod end Port (Point N2) of left stabilizer cylinder as
shown in Fig. 16. Using a plastic hose tie, fasten the
hose to the stabilizer cylinder approximately 2” below
the base end Port.
Fig 15
Fig. 16
(16) Connect end of “left stabilizer down” hose (Item
12) equipped with long 90° fitting to Port (Point
P1) on far left hand valve section as shown in Fig. 15.
Route hose as in Step 15 and connect to the base Port
(Point P2) on left stabilizer as shown in Fig. 16.
NOTE: For backhoe / tractor hydraulic interface, see
mounting frame installation sheet.
M2
L2
N2
P2
M1
L1
P1
N1
To Next Page
Loading...