BMW F800R - Remote Control Battery Replacement

automatically 30 seconds after
completion of the last step in
the programming routine
The anti-theft alarm LED goes
out and four acknowledgement
tones sound.
Registering additional
remote controls
with alarm system (DWA)
OE
When is it necessary to
register a remote control?
If you want to register an addi-
tional remote control or register
a remote control as a replace-
ment for one that has been mis-
laid, you must always register all
the remote control units with the
anti-theft alarm. You can register
a maximum of four remote con-
trol units.
Registering remote
control
Deactivate the alarm function.
Switch on the ignition.
Press button 2 three times.
Acknowledgement tone sounds
once.
Within ten seconds, switch off
the ignition.
Press button 2 three times.
Acknowledgement tone sounds
once.
Within ten seconds, switch on
the ignition.
Acknowledgement tone sounds
twice.
You can now register a maximum
of four remote control units with
the anti-theft alarm. Registration
is a three-step process and has
to be repeated for each remote
control unit.
Press and hold down button 1
and button 2.
LED flashes for ten seconds.
As soon as the LED goes out,
release button 1 and button 2.
LED lights up.
Press button 1 or button 2.
Alarm tone sounds once.
LED goes out.
Remote control has been re-
gistered.
Repeat this three-step proced-
ure for each additional remote
control.
6
66
z Anti-theft alarm