In order to ensure the depend-
ability of the brake system, do
not permit the brake pads to
wear past the minimum per-
missible thickness.
Have the brake pads replaced
by a specialist workshop,
preferably an authorised
BMW Motorrad dealer.
Checking brake-fluid
level, front brakes
WARNING
Not enough brake fluid in
brake fluid reservoir.
Considerably reduced braking
power due to air in the brake
system.
Check the brake-fluid level at
regular intervals.
Make sure the ground is level
and firm and hold the motor-
cycle upright.
with centre stand
OE
Make sure the ground is level
and firm and place the motor-
cycle on its centre stand.
Move the handlebars to the
straight-ahead position.
Check the brake fluid level in
front reservoir 1.
NOTICE
Wear of the brake pads causes
the brake fluid level in the reser-
voir to sink.
Brake fluid level, front
(visual inspection)
Brake fluid, DOT4
Do not permit the brake fluid
level to drop below the MIN
mark.
If the brake fluid level drops be-
low the permitted level:
Have the defect rectified as
quickly as possible by a spe-
cialist workshop, preferably
an authorised BMW Motorrad
dealer.
9
97
z
Maintenance
To Next Page
Loading...
