Allow engine on support mo-
torcycle to run while jump-
starting.
Begin by connecting one end
of the red jumper cable to the
positive terminal 2 on the dis-
charged battery and the other
end to the positive terminal of
the donor battery.
Connect black jumper cable
to negative terminal on donor
battery and then to negative
terminal 1 of discharged bat-
tery.
Start engine of motorcycle with
discharged battery in usual
way; if engine does not start,
wait a few minutes before re-
peating attempt in order to pro-
tect starter motor and donor
battery.
Allow both engines to idle for a
few minutes before disconnect-
ing jumper cables.
Disconnect jumper cable from
negative terminals first, then
disconnect second cable from
positive terminals.
Attach and hook in battery car-
rier 2.
Fit the screw 1.
Installing rider's seat ( 38).
Battery
Maintenance instructions
Correct upkeep, recharging and
storage will prolong the life of the
lithium ion battery and are es-
sential for recognition of warranty
claims.
Compliance with the points be-
low is important in order to maxi-
mize battery life:
Keep the surface of the battery
clean and dry.
Do not open the battery.
Only charge the battery using
a charger that is suitable for
lithium ion batteries.
Be sure to read and comply
with the instructions for charg-
ing the battery on the following
pages.
9
134
z
Maintenance
To Next Page
