forwards. Make sure that the belt adjusters of
the bottom hooks point to the front.
4. Hook the two lower hooks of the luggage
compartment partition net into the two front
eyes on the folded-down rear seat backrest,
arrows 2. The rear seat backrests may need
to be raised a little to do this.
5. Tighten the luggage compartment partition
net with the two belt adjusters.
With the rear seat backrest upright
1.
Remove the luggage compartment cover.
2. Fold up the rear cover caps on the roof frame
at the top until they lock into place.
3. Insert both upper fastening pins of the lug‐
gage compartment partition net into the hold‐
ers as far as they will go, arrow 1, and slide
forwards.
4. Hook the two lower hooks of the luggage
compartment partition net into the two eyes
on the rear seat backrest, arrows 2.
5. Tighten the luggage compartment partition
net with the two belt adjusters.
Stowing the partition net
The luggage compartment partition net can be
stowed under the luggage compartment floor.
1.
Remove the luggage compartment partition
net.
2. Roll up the partition net and pack it with the
hook and loop tape.
3. Fold down the luggage compartment floor.
4. Stow the partition net on the left under the
side trim panel and lower on the right. The
securing pins must point up.
5. Press the luggage compartment floor down‐
wards.
Seite 310
CONTROLS
Luggage compartment
310
Online Edition for Part no. 01405A38CB9 - VI/21
To Next Page
Loading...
