EN/23
11. Coding and concluding work
The DSP amplifier must also be recoded on cars with a DSP amplifier.
Procedure
– Connect the DIS/MoDIC to the car
– Switch the ignition "ON"
– Select "Coding ZCS"
– Enter the date and confirm with "Y" (MODIC only)
– Series "E53"
– Path: "1 Recoding"
– System: "DSP"
– Start the automatic coding (confirm by pressing "Y")
– After the message "Coding complete" appears on the monitor of the DIS/MoDIC, switch
"OFF" the ignition, wait for at least 10 seconds and then switch the ignition "ON" again
– Print out the error memory
– Conduct a function test
Language coding
The language coding can be repeated using the "Navigation CD-ROM operating software”.
Concluding work
Connect the battery
Conduct a function test
Assemble the car again following the instructions for its dismantling in reverse order.
Print out the error memory
Retrofit/Installation kit No. 65 90 0 025 169 Issue date: 10.2001
Installation instructions No. 01 29 0 030 090
To Next Page
Loading...
