1. Important information on installing the on-board monitor
and the navigation system
Only for use in the BMW dealer organisation.
The on-board monitor and navigation system may only be installed by a specialist workshop
that has the required special tools and manuals (servicing, repair, diagnostics, etc.).
Ensure that the cables/lines are not kinked or damaged as you install them in the car.
Additional cables/lines that you install must be secured with cable ties where
necessary.
Item numbers refer only to the overview drawings and to the texts next to the
appropriate figure.
Electrical knowledge required.
The on-board monitor radio / CD changer control cable is not supplied with the
installation kit and must be ordered separately for cars with a CD changer without a DSP
amplifier using the electronic parts catalogue (EPC).
Subject to technical modifications
Tools and equipment required
MoDIC III or DIS Cable lamp
1/2 inch socket set Angle cutter
1/4 inch socket set Universal knife
Set of Torx sockets Pneumatic saw
Set of Philips screwdrivers Oscillating saw
Set of flat screwdrivers Flat file
Set of short Philips screwdrivers Combination pliers
Angle drill Torque wrench
Set of drill bits Textile adhesive tape
Conical countersink Extraction system
EN/1
Retrofit/Installation kit No. 65 90 0 025 169 Issue date: 10.2001
Installation instructions No. 01 29 0 030 090
To Next Page
Loading...
