BMW X5 (E53) LHD - For the Installation of the On-Board Monito; To Prepare the Module Holder in the Instrument Panel

Carefully cut the cross strut (40) off the radio
module holder (41) along the top on-board
monitor holder (4) using an oscillating saw.
Ensure that you do not damage the top on-board
monitor holder (4) as you cut the strut. Deburr the
cross strut (40) using a file and place the two
speed nuts 4.2 mm (11) on the top on-board
monitor holder (4) from below.
6. To prepare the module holder in the instrument panel
for the installation of the on-board monitor
F 53 0724 B
41
40
4
11
11
EN/12
Retrofit/Installation kit No. 65 90 0 025 169 Issue date: 10.2001
Installation instructions No. 01 29 0 030 090