BobsCNC QUANTUM MINI User Manual

62
Step 1a Lay out two Gantry Side Supports (QG2) and a
completed Stepper Motor Mount Assembly.
Be sure that with the Bearings resting on the
table as shown to ensure the Stepper Motor
Wires are oriented in the correct direction as
shown.
Install two M4 Nuts and use small pieces of
tape to cover the T-slots on the bottom of the
Stepper Motor Mount Assembly.

BobsCNC QUANTUM MINI Specifications

General

Brand	BobsCNC
Model	QUANTUM MINI
Category	Industrial Equipment
Language	English