bObsweep Bob Pro - Filters; Cleaning Bob’s Filters

Quick Start
Parts and Maintenance
Filters
Filter Frame
High-Efciency Filter
For ne particles
Electrostatic Filter
For smaller particles
Filters
To maximize Bob’s efciency, it is best to clean his lters about once a week and replace them about
once every 6 months. Three lters are located inside the dustbin. These lters capture ne particles and
prevent them from escaping the dustbin.
1. Push down the tab on Bob’s back and
slide the dustbin out.
4. Replace the lters and the lter tray.
Close the dustbin and slide it back
into Bob.
3. Remove the lters and brush them with
Bob’s cleaning tool.
Cleaning Bob’s Filters
2.
Lift the tab to open the dustbin. Lift the
lter tray out, using the tabs for leverage.
Parts You’ll Need: Cleaning Tool
Do not wash the dustbin
without removing the lters
rst.
When replacing the lters,
make sure the tab on the
high-efciency lter faces
up.
Quick Tips:
4241