29
Driver Installation
IF YOU SELECTED CUSTOM SETUP, you will be presented with the
choices shown below, depending on the CD-ROM type you selected. In
most cases, the defaults will be satisfactory.
IF YOU SELECTED EXPRESS SETUP, continue with step 8.
SONY Panasonic Mitsumi
I/O Address I/O Address I/O Address IRQ
320 320 320 5
330* 340 (default) 330* 7
340
(default) 340 (default) 9*
360 360 10
11 (default)
* selecting 330 and IRQ9 is not recommended.
For IDE CD-ROMs: The settings for an IDE CD-ROM are fixed at I/O
address 170 and IRQ15. Make sure you enable the J5 jumper on the
SE1440 if you have an IDE CD-ROM and will use the SE1440 as the CD-
ROM adapter card. After you are satisfied with your choices, continue
with the installation.
To Next Page
Loading...