Bodor Welder 1500 Pro - 7- Protective Mirror Replacement

BodorWelder Fiber Laser User Manual-V1.1
Bodor Inc.
7- Protective mirror replacement
1. Before operation, please clean and dry your hands first, and then wipe your
hands again with cotton dipped in alcohol.
2. Open the cover of the mirror compartment in a clean and dust-free place, pull
out the lens holder, do a good job of protection (covered with paper), check the
protective lens, if there is an obvious burning point on the surface of the lens, it
should be replaced directly.
3.Then check the flooding seal below the lens. If there are any scratches or
deformations on the plug seal, it cannot be used and must be replaced immediately;