BodorWelder Fiber Laser User Manual-V1.1
Bodor Inc.
in other places except the workpiece, so as to avoid potential safety risks caused by
abnormal light;
（4）The welding operation of handheld laser welding machine shall be carried
out in a separate space with laser protection; non-welding personnel and combustible
and flammable materials should be more than 10 meters away from the welding table,
and fire extinguishers should be placed near the welding area;
（5）A face mask should be worn when welding the high reverse material;
（ 6 ） Ensure that the handheld laser welding machine is grounded normally,
otherwise it may cause the electrification of the product shell and personal injury to
the operator; if the grounding is not operated as required, it may cause laser alarm,
light, laser instability and other hidden faults;
（7）Do not work in the rainy and direct sunlight environment, otherwise it may
cause high temperature and high humidity alarm or short circuit, affect the normal use
of the laser, and even cause safety risks.
2-Intended use and reasonably foreseeable misuse
1. Intended use
This product uses a high-energy density laser beam as a heat source to achieve
laser welding and cutting functions by locally heating and melting the base material.
This product can achieve the same welding of metal materials such as steel, aluminum,
copper, and stainless steel, as well as the mutual welding between carbon steel,
stainless steel, and galvanized sheet.
2. Reasonably foreseeable misuse
(1) Low melting point materials
Materials such as zinc, lead, tin, etc. have lower melting points and are prone to
vaporization during laser welding, resulting in the inability to form good welding
joints.
(2) Oxide materials
To Next Page
Loading...