Operating instructions Typ 2200 5 / 32
Betriebsanleitung Typ 2200
1 Basic safety instructions for the electronic
controller
DANGER!
Risk of accidents from improper installation
Installing the controller or the connected equipment improperly may cause the
device to fail and lead to serious or even fatal personal injuries. You must
therefore follow the general safety regulations for equipment in industrial
electrical systems and pay particular attention to the following points:
• The controller must be installed by qualified specialist staff only (as defined
by the guidelines IEC 364, DIN VDE 0105 for electrical equipment).
• The laws, guidelines, directives and regulations for the installation of
electrical equipment which are valid at the location for installation must be
adhered to.
• Settings on devices with protection class IP00 without covers must only be
made by authorised specialist staff when the devices are switched off. The
local regulations for safety and the prevention of accidents must be
observed.
• The controller must only be operated within the permitted area of application.
To Next Page
Loading...