Pull the starter rope with the starter handle (1) out completely
Ä Fig. 66.
Secure the coil (2) against winding up.
Loosen the knot of the starter rope on the coil and remove
the old starter rope.
Carefully turn the coil back, until the recoil spring is relieved.
Thread in the new starter rope and fix it with knots on both
ends Ä
Fig. 67.
NOTICE!
Incorrect sense of rotation will damage the spring ends
of the recoil spring.
Pre-tension the coil by approx. 4 rotations in direction of
arrow. Thereby place the starter rope into the recess in the
coil Ä
Fig. 68.
WARNING!
Danger of injury!
Do not let the starter handle hit back, but guide it back
slowly.
Slowly guide the starter handle back to initial position
Ä Fig. 69. The rope is thereby wound on the coil.
Test function and light movement of the recoil starter by
pulling the starter handle.
Mount the recoil starter to the engine housing.
Fig. 66
Fig. 67
Fig. 68
Fig. 69
Maintenance – Annual maintenance
BPR 50/55 D / BPR 60/65 D
72
Go to Discount-Equipment.com to order your parts
To Next Page
Loading...
