29
For the user
GB
How to disable the sound alarm
To disable the sound just touch one of the keys.
Operating again the oven
Once a semi-automatic or automatic cooking has expired, on the
display appear the current time and the blinking A symbol. In this
condition, the heating elements and the light bulb of the oven are
disabled.
To enable again the oven, just touch and keep the M key up to
see the symbol (2) on the display and the A symbol disappears.
THE OTHERS PROGRAMMER FUNCTIONS
How to delete a cooking time - Semi- automatic or Automatic
To delete a semi-automatic or automatic cooking program, with the
A symbol on, touch together the - and + keys for a least 2 seconds
or anyway up to see the (2) symbol and the disabling of A symbol.
How to delete the countdown timer
To delete the counting of the timer, which symbol is (4), touch the
M key for at least 2 seconds or anyway up to see the (4) symbol
blinking.
Touch together the - and + keys.
Checking the function settings
The set or remaining time of every cooking function of the program-
mer can be recalled to the display by entering in program mode
with the M key. Touch and keep the M key for almost 2 seconds
or anyway up to see the (4) symbol. The remaining time appears
on the display, or a series of zero numbers if the timer is disabled.
Touch again the M key. On the display appears the “dur” writing,
then alternately the remaining time or a series of zero number
(disable timer).
By touching again the M key, the end of cooking time appears
together with the “End” writing.
How to change the current time or the sound level
With the programmer in standard mode, the (2) symbol is on
touch together the - and + keys for at least 2 seconds or
anyway up to see the
dot (3) blinking.
To update the hour on the display: touch the - and + keys.
To change the sound level: touch the M key.
On the display appears the writing : to n... followed by a
number. Select whit the - key your favourite sound level.
Note: number 1 is referred
to the highest sound level. The
avail-able levels are 3.
Warning:
Power cut causes the loss of any program, even the
clock. That means the programmer will have to be set
again.
GENERAL PRECAUTIONS
A number of fundamental precautions must be complied with
when using household electrical appliances. In particular:
- The ceramic-glass hob has good mechanical strength and thus
withstands small accidental knocks. If the knob is broken or
cracked by a knock, do not use the appliance, disconnect the
power supply and contact your dealer.
Advice in case of malfunctions
Before contacting your After-Sales Service, check that:
- the plug is tted properly into the mains socket;
- the master pilot is on.
If the problem persists, consult a qualied, authorised technician
capable of repairing the fault.
If the oven light does not work, proceed as follows:
- Disconnect the power supply. Remove the protective glass on
the back of the oven and replace the bulb
No liability is accepted for injury or damage caused by poor
installation or improper use of the cooker.
HOW TO USE THE ROTISSERIE
a) Grilling with the door open.
- fit the knob guard as shown in fig. 13;
- impale the meat to be cooked on the spit and fix it in the centre
using the two forks provided;
- insert the tip of the spit into the rotation hub on the frame (see fig.
14);
- take the handle off the spit;
- place the spit support frame in the central runner of the oven, at
the same time inserting the rotation shaft into the motor hub (see
fig. 15);
- place the drip tray on the bottom runner of the oven and pour a
little water into it;
- light the grill burner;
- close the door gently, resting it on the knob guard;
- start the motor by pressing the switch on the control panel;
- baste the meat from time to time. When it is cooked, remove the
frame from the motor hub and screw the handle back on to the
spit.
b) Grilling with the door closed.
- as above without using the knob protection as shown in fig.13
CAUTION: The spit forks may have sharp points. Handle with care.
OVEN LIGHT/ROTISSERIE SWITCH
- Gas cooker models are fitted with a round switch;
- press this to turn on both the oven light and the rotisserie motor;
- gas-electric cookers (1 or 2 electric plates) are equipped with a
round switch with a red pilot light;
- his light comes on while 1 or 2 electric plates are in operation.
OPTIONAL MULTIPLE SPIT KIT
- Your rotisserie (which has 2 forks) can be equipped with an addi-
tional multiple spit mechanism.
- This can be ordered from your dealer at an additional charge.
FITTING THE MULTIPLE SPIT
- Remove the standard forks;
- place and secure the flanges on the spit element as shown in figure
16;
- impale the foods on the spits;
- insert the spits on the flanges as shown in figure 16;
- CAUTION: the two identical flanges "A" must be placed at the
ends.
FOR COOKERS WITH MECHANICAL SPRING CLOCK ( fig.17 )
The spring clock can be set for a maximum time of one hour by turning
the regulator knob clockwise to the time required. After the pre-set
time, a buzzer sounds and will stop automatically. When the buzzer
sounds, the spring clock does not cut out operation of the oven.
USE OF THE ELECTRONIC TIMER (fig. 18)
This allows the start time and cooking duration time to be programmed.
If food does not need to be watched, this timer can be selected even
when the user is absent. Soon after installation and at any electrical
supply cut-outs the display flashes; the clock must then be synchro-
nized again to allow programming.
SETTING THE TIMER TO THE CURRENT TIME
- The current time is set by pressing the 2 buttons (COOKING TIME
and STOP) and the "+" or "-" button at the same time.
To Next Page
Loading...