Keypad medical alarm report 0126 0
Automatic test report 0127 6
EN=1/5/6/7
0 = no report, 1 = receiver 1, 2 = receiver 2, 3 = receiver 3, 4 = receiver 4, 5 = receiver 1,2,3,4,
6 = receiver 1 (2,3,4 for backup), 7 = receiver 1 (2 for backup), receiver 3 (4 for backup), 8 =
receiver 1,2, 9 = 1 (2 for backup), 10 = receiver 3,4, 11 = receiver 3 (4 for backup)
Report delay entry time (00 - 99 = 0 – 99 sec.) 1669 – 1670 30
Notice!
When the transmission format for receiver in the receiver programming is set to 0 (not used),
i.e. setting the report option as sending report to a receiver, then the AMAX panel will actually
not send any report.
Automatic Test Report
Option Address Default
Automatic test report time: interval
00 = Do not use timing report , 01 - 24 = 1 - 24 hours
0128 – 0129 24
VDS-A
EN=1-24
Automatic report time: hour
00 - 99 = 0 - 99 hours, others = do not use real-time report
0130 – 0131 99
Automatic report time: minute
00 - 99 = 0 - 99 minutes, others = do not use real-time
report
0132 – 0133 99
Automatic report expiry time
000 – 999 = 000 – 999 minutes
0134 – 0136 000
AC Fault Domestic No.
Option
Address Default
AC fault domestic no. (0 = no report,
1 = destination 1,
2 = destination 2,
3 = destination 3,
4 = destination 4,
5 = destination 1, 2, 3 and 4,
6 = destination 1 (2, 3, 4 for backup),
7 = destination 1, 3 (2, 4 for backup))
0137 0
AC Fault Report by Receiver
Option
Address Default
AC fault report by receiver (0 – 7) 0138 6
114 en | Address Programming AMAX panel
2015.05 | 06 | F.01U.309.277 Installation Manual Bosch Sicherheitssysteme GmbH
To Next Page
Loading...
