Notice!
The AMC2-4WE has no display. The information about the input
and outputs will be shown on special pages of the AMC2
display.
As the extension modules contain neither memory nor display
they are controlled and monitored entirely by the AMC2-4W.
The AMC2-4W can have an additional interface extension
module AMC2-4WE, so that the number of inputs and outputs
can grow up to 64.
Notice!
An AMC2-4WE provides signals only to the AMC2 to which it is
connected. Signal transfer to another AMC2 is not possible.
The signal settings and parametrization of the readers
connected to the extension module, are carried out by the
configuration applications in the access control system and by
the AMC2-4W to which it belongs.
AMC2 Wiegand
Extension
Introduction | en 13
Bosch Sicherheitssysteme GmbH 2016-11 | AMC2-4WE |
To Next Page
Loading...
