AUTODOME IP starlight 5100i IR (Optional) Configuration Programming on a Temporary Table-top Stand | en 15
Bosch Security Systems
Installation Manual
2021-02-19 | 0.7 |
5 (Optional) Configuration Programming on a Temporary
Table-top Stand
5.1 Installation Overview
Caution!
Risk of damage to camera
Please remove the tape from the top of the camera. The camera head must be free to rotate.
Caution!
ELECTRIC SHOCK HAZARD
To reduce the risk of electric shock, disconnect power to the camera and/or to the power
supply unit before moving the camera, before installing any accessories, and before mounting
the camera.
Caution!
Type and source of hazard
Take extra care lifting or moving cameras because of their weight.
5.2 Configuration Programming on a Temporary Table-top Stand
The camera packaging with a PE form as a base plate allows installers to configure the
camera.
1. Remove the foam covering the head of the camera.
2. Remove the camera from the box.
3. Change the camera orientation to inverted.
4. Put the PE foam on a flat, horizontal surface.
5. Put the camera upright in the PE foam as a base plate.
6. Supply power to the camera and Connect the camera to the computer. Note that the
wiper moves one to three times across the camera window, and then returns to parked
position.
To Next Page
Loading...
