20 en | Installing the IP66 kit AUTODOME IP starlight 5100i IR
2021-02-19 | 0.7 |
Installation Manual
Bosch Security Systems
2. Put the grommet on the RJ45 socket on the camera cable on the camera.
Note: Do not complete the steps that follow until you are ready to complete step 7 of the
subchapter Attaching the Mounting Cap and the Camera. This subchapter is in the
installation chapter of every mount for the camera.
1. Connect the RJ45 plug and the RJ45 socket on the camera cable.
2. Connect the IP66 waterproof kit on the camera cable. It will make a click if inset
successfully. Use the outer casing cover the side on camera.
3. Screw the cap on the outer casing tightly.
4. Finish the assembly of the kit.
To Next Page
Loading...
