Bosch AVIOTEC IP starlight 8000 - Page 30

Auxilliary 12 V DC power supply
!
Caution!
Use only a +12 VDC power supply as an auxiliary power source.
The auxiliary power supply unit must be isolated from earth.
!
Caution!
The Low Voltage power supply unit must comply with EN/UL 60950. The power supply must
be a SELV-LPS unit or a SELV - Class 2 unit (Safety Extra Low Voltage - Limited Power
Source).
The camera can be supplied with a power supply in case of missing PoE feature of the
network or for redundancy reasons.
Connect an approved power supply unit with a rated supply voltage of 12 VDC as follows:
1. Strip back 7 mm (0.28 in) of insulation on the power supply cable (must be 16-28 AWG,
UL 14-30 AWG).
2. Loosen the screws of the supplied 2-pole connector and insert the stripped wires, then
tighten the screws again.
3. Insert the 2-pole connector into the camera power socket.
30 en | Installation AVIOTEC IP starlight 8000
2017.06 | 6.0 | F.01U.318.200 Operation manual Bosch Sicherheitssysteme GmbH