Bosch AVIOTEC IP starlight 8000 - Page 41

Automask
Notice!
All automasks stored in the volatile alarm memory of the camera are lost when the supply
voltage is interrupted or switched off. Automasks that already have been saved will remain
unaffected.
Notice!
If you change the settings of Min. size or Verification time [s], it is necessary to renew the
automasks.
1. Navigate to Configuration > Alarm > Fire detection.
2. Select Automask
The system automatically generates predefined masks from the alarm memory. The
automasks are illustrated as rectangles with red dashed border.
3. Adjust the automask to your specific needs.
If it is necessary, you can add individual masks (Add mask).
4. Select Set to confirm the changes.
P Automasks were added to the system.
Reset user interface
Notice!
All determined masks in the user interface will be deleted! Only automasks remain stored in
the alarm memory and can be regenerated.
If you want to reset the user interface to standard values:
1. Click on Defaults.
2. Press OK to confirm.
P The system resets the user interface for fire detection to the standard settings.
Delete Automasks
Notice!
Delete automasks if you changed the camera position, zoom, point of view or after a fire. Also
delete automasks if the spatial arrangement of objects in the detection area has changed
fundamentally.
To delete the automasks for Flame detection from the alarm memory:
1. Navigate to Fire detection > Flames > Detection.
2. Select Off and press Set.
3. Select On and press Set.
P Automasks for Flame were deleted.
To delete the automasks for Smoke detection from the alarm memory:
1. Navigate to Fire detection > Smoke > Detection.
2. Select Off and press Set.
AVIOTEC IP starlight 8000 Adjustment of detection settings | en 41
Bosch Sicherheitssysteme GmbH Operation manual 2017.06 | 6.0 | F.01U.318.200