Bosch B426 - Page 24

Web Access Enable
Default: Yes
Selections: Yes, No
Yes: Web configuration is enabled
No: Web configuration is disabled
Enable or disable access to the configuration web pages.
Do NOT disable web access unless you are on a SDI2 panel with Panel Programming Enable
enabled. With SDI and option control panels, the module can only be configured via the web
interface.
Panel Programming Enable
Default: Yes
Selections: Yes, No
Yes: Control panel programming is enabled.
No: Control panel programming is disabled.
Enable or disable control panel programming of the module with compatible control panels.
Do not disable Web Access Enable and Panel Programming Enable. If both are disabled, you
cannot configure the module.
Firmware Upgrade Enable
Default: No
Selections: Yes, No
Yes: Allows firmware upgrades to the B426 using the network.
No: Prevents firmware upgrades.
Enable or disable the ability to upgrade the module's firmware from the Firmware Upgrade
configuration page.
Module Hostname
Default: Blank
Selections: Sixty-four alphanumeric characters
Blank: Blank restores the default hostname Bxxxxxx, where as xxxxxx is the last six digits of
the module’s MAC address.
Use this parameter to create or change a module hostname. This is the hostname that
represents the module on the network. The hostname can be used to contact the control
panel via RPS over network for Remote Security Control, or for the purposes of web
configuration and diagnostics of themodule .
Unit Description
Default: Blank
Selections: Twenty alphanumeric characters
Use this parameter to create a simple description for the unit.
24
en | Configuration
Conettix Ethernet Communication
Module
2013.08 | 02 | F.01U.281.208 Installation and Operation Guide (UL) Bosch Security Systems, Inc.