Bosch B426 - Overview; Bus Address Settings

B426 module overview
1
4
5
7
9
6
TX
RX
R PWR
G B
Y A
B COM
MODE
8
TMPR
3
LINK
100 MB
2
Figure 3.2: B426 Conettix Ethernet Communication Module
Callout ᅳ Description
1 ᅳ Ethernet RJ-45 port
2 ᅳ Yellow LINK LED
3 ᅳ Green 100MB LED
4 ᅳ Data bus communication LEDs (TX and RX)
5 ᅳ Heartbeat LED
6 ᅳ Address switch
7 ᅳ Terminal strip (to control panel)
8 ᅳ Interconnect wiring connectors (to control panel or other compatible modules)
9 ᅳ Tamper switch connector
Overview
The B426 Conettix Ethernet Communication Module is a four-wire powered SDI, SDI2, or
option bus device that provides two-way communication with compatible control panels over
IPv6 or IPv4 Ethernet networks.
The B426 on-board switch determines the bus address of the device. Configuration of the
B426 is performed through the B426 configuration web pages. On SDI2 control panels,
configuration can also be done on the keypad or through Remote Programming Software
(RPS). The B426 Conettix Ethernet Communication Module is compatible with IPv6.
Bus address settings
The address switch determines the bus address for the B426 Conettix Ethernet
Communication Module. The control panel uses the address for communications. Use a
slotted screwdriver to set the address switch.
3.1
3.2
8 en | System overview
Conettix Ethernet Communication
Module
2013.08 | 02 | F.01U.281.208 Installation and Operation Guide (UL) Bosch Security Systems, Inc.