Bosch B426 - Table of Contents

Table of contents
1
Safety 4
2
Introduction 5
2.1 About documentation 5
2.2 Bosch Security Systems, Inc. product manufacturing dates 5
3
System overview 6
3.1 Overview 8
3.2 Bus address settings 8
4
Installation 10
4.1 Mount the module in the enclosure 10
4.2 Mount and wire the tamper switch (optional) 10
4.3 Wire to the control panel 10
5
Configuration 13
5.1 Configure for SDI2 control panels 13
5.2 Configure for SDI or option bus control panels 13
5.2.1 Plug and Play configuration 13
5.2.2 Web-based configuration 13
5.3 Determine a module's hostname or IP address 14
5.3.1 Determine a module’s hostname 14
5.3.2 Use an SDI/SDI2 keypad or RPS to discover the IP address of a module 14
5.3.3 Use DHCP to look up the IP address of a network-connected module 14
5.3.4 Use AutoIP with a directly connected module 14
5.4 Use web-based configuration menus 16
5.5 Device Information (home) page 16
5.6 Change and save settings using the web 17
5.7 Basic Network Settings page 17
5.8 Advanced Network Settings page 20
5.9 Panel Address Settings page 21
5.10 Encryption and Security Settings page 22
5.11 Maintenance page 23
5.12 Factory Default page 25
5.13 Firmware Update page 25
5.14 Exiting the web-based configuration pages 26
6
Maintenance and troubleshooting LEDs 27
6.1 Show the firmware version 28
7
Specifications and certifications 29
7.1 Technical specifications 29
7.2 Certifications 30
Conettix Ethernet Communication
Module
Table of Contents | en 3
Bosch Security Systems, Inc. Installation and Operation Guide (UL) 2013.08 | 02 | F.01U.281.208