Bosch B4512 - RF Repeater Menu > [2] Replace Repeater

B91x/B92x keypads configuration of Add Repeater
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to [2] Wireless > [2] RF Repeater Menu > [1] Add Repeater. The keypad lists any
repeaters.
3. Use [PREV] or [NEXT] to scroll though the list, and go to the repeater number for which
you want to add a repeater, or simply enter the repeater number.
4. Press [ENTER] to add the device. The keypad instructs you to reset the device.
5. Initiate discovery on a RADION device per the device instructions, or press the RESET
button on an Inovonics device.
6. When the keypad shows Repeater Added, escape from the menu.
B93x/B94x keypads configuration of Add Repeater
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to [2] Program > [2] RF Repeater Menu > [1] Add Repeater. The keypad lists any
repeaters.
3. Use
/[PREV] or /[NEXT] to scroll though the list, and go to the repeater number for
which you want to add a repeater, or simply enter the repeater number.
4. Press [ENTER] to add the device to the number. The keypad instructs you to reset the
device.
5. Initiate discovery on a RADION device per the device instructions, or press the RESET
button on an Inovonics device.
6. When the keypad shows Repeater Added, escape from the menu.
[2] RF Repeater Menu > [2] Replace Repeater
In this menu, you can replace Repeater points.
Replace Repeater
B91x/B92x keypads use of Replace Repeater
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to [2] Wireless > [2] RF Repeater Menu > [2] Replace Repeater. The keypad lists any
existing repeaters.
3. Use [PREV] or [NEXT] to scroll though the list of repeaters, and go to the repeater you
want to replace, or simply enter the repeater number.
4. Press [ENTER] to replace the device. The keypad instructs you to reset the new device.
5. Initiate discovery on a RADION device per the device instructions, or press the RESET
button on an Inovonics device.
6. When the keypad shows Repeater Replaced, escape from the menu.
B93x/B94x keypads use of Replace Repeater
1. Enter the installer passcode, and then open the [1] Installer menu.
2. Go to [2] Program > [2] RF Repeater Menu > [2] Replace Repeater. The keypad lists any
existing repeaters.
3. Use
/[PREV] or /[NEXT] to scroll though the list of repeaters, and go to the repeater
you want to replace, or simply enter the repeater number.
4. Press [ENTER] to replace the device. The keypad instructs you to reset the new device.
5. Initiate discovery on a RADION device per the device instructions, or press the RESET
button on an Inovonics device.
6. When the keypad shows Repeater Replaced, escape from the menu.
19.2.5
136 en | Keypad Installer menu Control Panel
2015.07 | 12 | F.01U.287.180 Installation and System Reference Guide Bosch Security Systems, Inc.