Installation checklist
Before installing and operating the control panel, read these instructions. Failure to follow
these procedures may cause the device not to function properly. Bosch Security Systems Inc.
is not responsible for any devices that are improperly installed, tested, or maintained.
This document does not contain special information about local requirements and safety
issues. Information on such issues is provided only to the extent that it is needed for
operation of the device. Ensure that you are familiar with all safety-related processes and
regulations in your area. This also includes how to act in the event of an alarm and the initial
steps to take if a fire breaks out. The operating instructions should always be available on site.
It is a required part of the system and must be given to the new owner if the system is ever
sold.
Use the workflow and checkboxes below as you complete steps. Each step includes
references for more detailed information.
Install the enclosure and wiring label
– Install the enclosure and wiring label, page 23
Install the control panel
– Mount the control panel, page 23
– Connect earth ground, page 25
– Configure OUTPUT A using the jumper, page 25
Install and wire for telephone communication
– Telephone communications, page 35
Install and wire for IP communications
– IP communications, page 39
Install and wire the battery and the transformer
– Power supply, page 28
Begin to charge the battery while you install other devices
– Charge the battery
Install and wire arming devices
– Keypads, keyswitches, keyfobs and transmitters, page 52
Install and wire outputs
– On-board outputs, page 58
– Off-board outputs, page 60
Install and wire inputs
– On-board points, page 63
– Off-board points, page 66
– Wireless modules, page 71
Complete the installation
– Program and test the control panel, page 74
4
22 en | Installation checklist Control Panel
2015.07 | 12 | F.01U.287.180 Installation and System Reference Guide Bosch Security Systems, Inc.
To Next Page
Loading...
