Bell requirements
Use the following Rothenbuhler bell and balanced line modules with the control panel:
– UL Listed Model 5110 Bell
– UL Listed Model 4001-42 External Line Balancer
Wiring information for installations using the Rothenbuhler 5110/4001-42 High Security Bell
Refer to the following two figures for wiring information.
Figure 18.1: Rothenbuhler 5110 4001-42 High Security Bell to control panel wiring
Callout á…³ Description
Callout á…³ Description
1 á…³ Self-contained UL listed vibration sensor 9 á…³ D122/D122L Dual Battery Harness
2
2 á…³ Control panel 10 á…³ D126 Battery
3 á…³ Accessory modules 11 á…³ D8108A Enclosure
4 á…³ High line security module 12 á…³ Proximity/control unit
5 á…³ 4001-42 Balanced Line Module 13 á…³ Normally open (NO)
6 á…³ 5110 Bell 14 á…³ Normally closed (NC)
7 á…³ D133 Relay 15 á…³ End-of-line (EOL) resistor
8 á…³ Alarm input point
1
16 á…³ Safe
1
Use Terminals 1 through 8. (Select only one.)
2
Use a D113 Battery Lead Supervision Module to supervise the battery connections
.
Control Panel
Approved applications | en 91
Bosch Security Systems, Inc. Installation and System Reference Guide 2015.07 | 12 | F.01U.287.180
To Next Page
Loading...
