24
4.12 NO-Sensor
4.12.1 Read NO-Sensor
4.12.2 Set NO-Sensor
i This menu is only for BEA's equipped
with a retrofit NO measuring sensor!
This menu is used for monitoring, instal-
ling and checking the NO measuring sen-
sor.
Start the menu with E or by double-
clicking the mouse.
The following menus can be executed:
z Read NO-Sensor
z Set NO-Sensor
z NO-Measurement
z Mounting an new NO-Sensor
z Readjustment with test gas
z Calibration interval setting
z Calibration sequence setting
The status of the NO measuring sensor is
displayed in this menu.
In this menu, the BEA is informed as to
whether or not an NO measuring sensor is
installed.
Confirm your selection of this menu with
E or by double-clicking the mouse.
The OK box appears for 1 s.
To Next Page
Loading...
