Bosch CC 100 M - ZOOM function (magnification)

@) BOSCH
Flexible Automation
Description Stage 4 Chapter 1
CC lOOM
User Mannal
ZOOM .. i SCROLL • ~ RECORD
CURSOR
o Determining the magnification:
ZOOM ZOOM ZOOM RECORD
cURsoR +
The larger the ZOOM area displayed in reverse video mode is, the lower is the magnification.
RECORD r----l
The selection must be confirmed with softkey . When the Ne starts again,
the control starts the program and displays the ZOOM cursor.
Example:
a. Determining the position of the ·ZooM cursor":
----IP'---
b. Selecting the magnification.
c. Displaying a section of the sImulation area.
Difference between and
ZOOM
HORIZONTAL
The cursor at the canter of the workpiace (rectangle) is positioned horizontally (ZOOM HORIZON-
TAL) or positioned vertically (ZOOM VERTICAL).
1 -11
www.DaltonsWadkin.com
www.DaltonsWadkin.com
www.DaltonsWadkin.com