Bosch CC 100 M - Inputs on the manual panel; Definition

(@ BOSCH
Flexible Automation
Description Stage 4 .. Chapter 1
CC lOOM
User Manual
Inputs on the manual panel
Definition:
There are three terminals which have not been used to date on the rear of the manual panel. The
signals at these terminals are now evaluated in the PlC ?OO.
illustration (manual panel and arrangement of the PlC inputs E1 • E3):
)'-~; --. - J\:- ·-i 0- 00 0 0 ---~- --T
~L 8 ;)f~ 00000 0 -r
;";_, 'y 00000
800 ~
' .. ~ B [J El
fim.
60
- -<1>.- ---._- ----- --. - _.
X12 PIN 1 E2.5
PIN 2 E2.6
PIN 3 E2.7
NC outputs. PlC Inputs:
The statuses
01 the signals El - E3 are stored in the PlC input bits 2.5 to 2.7.
Display:
The statuses of the PlC input signals 2.5 -2.7 are displayed in the 1/0 status overview (group operating
mode INFORMATION).
The PlC input signals (El - E3) are listed with the PlC keys (Fl - F15) in the lollowing order under
criterion "MTB keys· in the list of the outputs:
Fll F12
Fl F2 F3 F4
Illustration (CC 100 M - 1/0 status):
10/19/57
AXES XYZE
Drive on HHHH
Axis allow
HHHH
Reference LLLL
SPINDLE ON H
Gear 1
L
Gear 2 L
Cyde Start L
Stop
H
Cyde stop
CC100M
STATUS
1 -35
F13 F14
F5 F6
1001 89
INPUTS
Edit allow H
Emergency stop H
Umit+ H
Limit - H
Travel 2
M Roock·m.
Jump Cond.
Online PlC
Pan. A edit E
MTBoff
H
L
LL
L
LH
LLLLLLLL
MESSAGE
LIST
F15
F7
F8 F9
Information
OUTPUTS
Prg. gesplbcd ok
Time error
Start I stop
Entry
active
On line PICIDNC
dne start I SlOp
DRY RUN I RAPID
Prog. run
E
active
in Pos XYZES
LL
L
LH
L
LL
Fl0
MrB·keys LLLLLLLL ~
OTHER
SELECTION
LLLLLLLLLL
PICIPLC
DISPLAY
www.DaltonsWadkin.com
www.DaltonsWadkin.com
www.DaltonsWadkin.com