§l
BOSCH
Flexible Automation
Description Stage 4 Chapter 2
CC
lOOM
User Manual
2nd Handwheel (option)
Function:
A 2nd electronic handwheel can be activated
in
the CC lOOM. The second handwheel acts only on
the
X
axis,
whilst
the
first
handwheel
ca.n
be switched
to
the
Y,
Z or E
axis
via
the
axis
selector
switch.
This
means that
two
axes
can
be
moved mutually independently with
toNo
hancfwheels.
The
function
2nd handwheel is an option and must be activated in the control.
Commissioning, Interaction:
The new manual panel (EBF) is equipped
with
an
additional WeidmOller terminal (see marked
position
in
the figure below). This terminal is provided for the 2nd handwheel.
------
The machine parameter 2 (2nd handwheel only for X axis) must be set to Y. The function of the
2nd handwheel
is
evaluated when the machine parameter is changed accordingly.
If
the 2nd
handwheel is actlve
with
the axis selector switch set
to
X, an axis movement in X via the 1st
handwhael is not possible. The feedrate potentiometer acts simultaneously for both handwheels.
Illustration
(connection on manual panel (EBF) for 2nd handwheel):
$
$
$ $ $
Dimensions:
37-pole
X23
9-pole
X13
9-pole
X12
$
9-pole
Xll
$
The dimensions of the 2nd hendwheel correspond to those
of
the 1 st handwheel (see drawing
below and dimension specifications). The 2nd
handwheel is designed for installation
in
a machine
operating panel
or
in a separate housing (mobile use).
Illustration:
:il
11
11
~
I.
eo
108
'I
I
2-1
-
To Next Page
Loading...
