Bosch CC 100 M - The simulation display

§ BOSCH
Flexible Automation
Description Stage 4 Chapter 1
The simulation display:
f - MILLING SIMULATION
CONDITIONS ON
1 OFF
CC lOOM
User Manual
When key 'SIMULATION ON" (group operating mode AUTOMATIC) is pressad, the control switches
over to display of the simulation parameters.
DIMENSIONS
X 300.0
Y 230.0
Z 80.0
POSITIONS
X 220.0
Y 140.0
Z 80.0
EVOLUTIVE AREA
X 550.0 -X 10.0
Y 400.0 -y 10.0
Z 150,0 -Z 10.0
UNIT : M
PLANE: ... X ty
WORK PIECE
DIMENSIONS
+
<1i
"'I "'
< i~;t
F." DIMENSIONS "'l~
I ~I
z
I ~I
~ _____ EJ
~POSITIONS
... ..
AREA-
....-..
.. AREA + ..
RECORD
ALL DATA
The following simulation parameters are available:
- Dimensions of the workpiece
- Position of the workpiece
- Determining the evolutive area
- Selection of the working plane
The parameter display offers the following sottkey bottom panel:
WORKPIECE WORKPIECE
DIMENSIONS POSITIONS
1-4
EVOLUTIVE
AREA
-1 PLANE
SELECTION
RECORD
ALL DATA
www.DaltonsWadkin.com
www.DaltonsWadkin.com
www.DaltonsWadkin.com