6 720 820 872 (2016/12) CR 400 | CW 400 | CW 800
26 | Service menu
Fig. 16 Overview of the service menu 2/4
1) Only available if no cascade module (e.g. MC 400) is
installed.
Boiler data
1)
Heating circuit 1 ... 8
Pump type Heating circuit installed
Pump run-on time Ctrl type h. circ. 1
Pump logic temperature User interface
Pump control mode Use minimum value
Pump rate min. output Heating system heat circ. 1
Pump rate max. output Set point constant
Pump block. time ext.3WV Max. flow temperature
Pump shutdown temp. Set heating curve
Maximum output Design temperature
Upper limit max. output End point
Max. DHW output Base point
Top limit max DHW output Max. flow temperature
Top limit max flow temp. Solar influence
Min. appliance output Room influence
Time interv (stdby period) Room temperature offset
TempInterv (StdbyPeriod) Fast heat-up
Duration of heat retention Setback type
Venting function Reduced mode below
Trap filling program Heat constantly below
Signal ext. heat req. Frost protect
Set value ext. heat req. Frost prot. limit temp.
AirCorrFact min fan power Mixer
AirCorrFact max fan pow. Mixer runtime
3 WV centre pos. Mixer increase
Emerg. altern. op. DHW priority
Turbine signal delay time Shown in standard display
Pump economy mode
Open-window detection
PID charact.
6 720 815 821-102.1O
To Next Page
Loading...
