2
Bosch Security Systems | 04-2003 | 3922 988 43318 en
Digital Congress Network | Installation and Operating Manual | Chapter 5 - Control using PC
en | 5-6
Connection PC to CCU
5.5 Connection PC to CCU
Two methods for connecting the DCN Control PC to the CCU are available:
1. ‘DIRECT’ connection from a serial COM-port of the DCN Control PC to the serial COM-port
of the CCU (not applicable for CCU type LBB 3500/05).
2. Using PC-Network card LBB 3510/00. (see Note 2). For installation details see Chapter 5.2.
NOTES:
1. This function is only possible when the ‘Windows® 95 or 98’ operating system installed
on the DCN Control PC. It is NOT possible when running under the ‘Windows® NT
4.0 and ‘Windows® 2000 operating systems.
2. Simultaneous use of the PC-Network card LBB 3510/00 and ‘DIRECT’ PC control is
NOT possible.
The examples shown in this chapter are:
1. SINGLE-CCU system with control PC and Camera control
2. Multi-CCU System with control PC and Camera control
For further information refer to Chapter 10.. Installation techniques
Get other manuals https://www.bkmanuals.com
To Next Page
