Bosch DIVAR IP all-in-one 4000 User Manual

DIVAR IP all-in-one 4000 System overview | en 17
Bosch Security Systems B.V.
Installation manual
2022-10 | V02 | F.01U.407.904
Control panel buttons
Button Description
Power
The power button is used to apply or remove power from the power supply to
the system.
Note: Turning off system power with this button removes the main power,
but keeps standby power supplied to the system.
To remove all power, unplug the system before performing maintenance
tasks.
Reset
The reset button is used to reboot the system.
Control panel LEDs
LED LED state Description
Power
Solid green This LED indicates that power is supplied to the system's
power supply unit.
This LED is illuminated when the system is operating.
HDD
Amber flashing This LED indicates activity on the HDDs or on peripheral
drives when flashing.
Network
Green flashing This LED indicates network activity when flashing.
Information
This LED indicates the system status.
Solid red An overheat condition has occurred. (This might be caused
by cable congestion.)
Blinking red
(1Hz)
Fan failure: check for an inoperative fan.
3.3 Hard drive tray LEDs
The device supports swappable SATA hard drives in hard drive trays. Each hard drive tray has
two LEDs on the front of the tray.
Note: For non-RAID configurations, some LED indications are not supported, for example hot
spare.
LED LED state Description
Upper hard
drive tray
LED
Green flashing Indicates HDD activity.

Bosch DIVAR IP all-in-one 4000 Specifications

General

Brand	Bosch
Model	DIVAR IP all-in-one 4000
Category	Recording Equipment
Language	English