EasyManuals Logo

Bosch DIVAR IP all-in-one 4000 User Manual

Bosch DIVAR IP all-in-one 4000
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
DIVAR IP all-in-one 4000 Installing a SATA hard drive | en 19
Bosch Security Systems B.V.
Installation manual
2022-10 | V02 | F.01U.407.904
4 Installing a SATA hard drive
DIVAR IP all-in-one 4000 has two front-swappable SATA hard drives. The hard drives are
mounted in hard drive trays to simplify their installation and removal from the chassis. The
hard drive trays also help promote proper airflow for the hard drive bays.
i
Notice!
Bosch strongly recommends to use hard drives approved and supplied by Bosch. The hard
drives as one of the critical component are carefully selected by Bosch based on available
failure rates.
Bosch is not liable for any data loss or damages, or system failures of units equipped with
hard drives that are not supplied by Bosch.
Bosch cannot provide support if non-Bosch-supplied hard drives are considered to be the
cause of the problem. To troubleshoot potential hardware issues, Bosch will require Bosch-
supplied hard drives to be installed.
For more information about Bosch-supplied hard drives, see the datasheet in the Bosch
online product catalog under:
www.boschsecurity.com
i
Notice!
Review the warnings and precautions listed in this manual before performing works on the
chassis.
Procedure
The installation procedure for Bosch-supplied hard drives and non-Bosch-supplied hard drives
differs.
Refer to
Installing a Bosch-supplied hard drive, page 19
Installing a non-Bosch-supplied hard drive, page 21
4.1 Installing a Bosch-supplied hard drive
i
Notice!
Hard drives supplied by Bosch come already pre-installed in a hard drive tray.
To install a Bosch-supplied hard drive, you must do the following:
1.
Removing a hard drive tray from a hard drive bay, page 19
.
2.
Installing a hard drive tray into a hard drive bay, page 20
.
Removing a hard drive tray from a hard drive bay
To remove a hard drive tray from a hard drive bay:
1. Unlock the front cover and swing it open.
2. Press the release button to the right of the hard drive tray. This extends the hard drive
tray handle.
3. Use the handle to pull the hard drive tray out of the chassis.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Bosch DIVAR IP all-in-one 4000 and is the answer not in the manual?

Bosch DIVAR IP all-in-one 4000 Specifications

General IconGeneral
BrandBosch
ModelDIVAR IP all-in-one 4000
CategoryRecording Equipment
LanguageEnglish

Related product manuals