6 en | Safety DIVAR IP all-in-one 4000
2022-10 | V02 | F.01U.407.904
Installation manual
Bosch Security Systems B.V.
Notice!
Permanently connected devices must have an external, readily operable mains plug or all‑pole
mains switch in accordance with installation rules.
Notice!
Pluggable devices must have an easily accessible electrical outlet installed near the
equipment.
Warning!
Interruption of mains supply:
Voltage is applied as soon as the mains plug is inserted into the mains socket.
However, for devices with a mains switch, the device is only ready for operation when the
mains switch (ON/OFF) is in the ON position. When the mains plug is pulled out of the
socket, the supply of power to the device is completely interrupted.
Warning!
Do not put any objects in the openings of this product. The objects may touch dangerous
voltage points or short-circuit components, which could result in a fire or electrical shock.
Caution!
Power supply cords
Make sure to route the power supply cords in a way so that they are protected from any
possible damage.
Warning!
To prevent electrical shock hazard, disconnect all power cables from the electrical outlet
before relocating the system.
Caution!
Disconnect power cables before installing or removing any components from the device.
Notice!
When disconnecting power, first turn off the system and then unplug the power cord from the
power supply module in the system.
Notice!
Be aware of the locations of the power on/off switch on the device as well as the room's
emergency power-off switch, disconnection switch or electrical outlet. If an electrical
accident occurs, you can then quickly remove power from the system.
To Next Page
Loading...
Need help?
General
