48 en | Installing the drive trays for the E2700 controller-drive tray configurations DSA E-Series (E2700)
2015.10 | V2 | DOC Installation manual Bosch Sicherheitssysteme GmbH
Notice!
Make sure that you do not turn on the power to the drive tray until this installation guide
instructs you to do so.
8.7 Procedure – connecting the power cords
To connect the power cords:
1. Make sure that the circuit breakers in the cabinet are turned off.
2. Make sure that both of the Power switches on the drive trays are turned off.
3. Connect the primary power cords from the cabinet to the external power source.
To Next Page
Loading...